For our customers from different industries, we develop products from lowest power (nA) to inverters and motor controllers in the kW range. The range of the microcontroller used goes from 4-bit to 64-bit controllers. Due to our in-house SMD production line, we are able to realize even the most complex prototypes in the shortest possible time.

• FPGA- and Processorboards
• Embedded Microcontroller designs
• Mixed analog/digital circuits
• Customer specific Interface Converters
• Sensor Interfaces
• Stepper, DC and BLDC Motor-Controllers
• Inverter and Switched Power Supply (SMPS)
• LED Drivers, LED Controllers
• RF Modules (BLE, WiFi, ISM, GSM etc)
• Ultra Low Power
• RFID
• IoT

We develop real time software for microcontrollers, PCs (Windows) and IOS devices (Apps). Depending on the application and requirements, we write our software in Assembler, C, C ++, Delphi or Objective C.

• Real ultra low power for battery driven devices
• Bus Systems
• Test Systems
• WiFi, GSM, USB, Bluetooth, BLE etc.
• Measurement and control technology
• Embedded Software Development
• Extreme time critical Real-Time Applications
• IoT

EMV Compliance

Thanks to in-house EMC measurement equipment, we can perform the most important EMC pre-compliance measurements already during the prototype phase.

The following Pre-Compliance Measurements can be performed In-House:

• ESD Measurements (air/contact) according to IEC/EN 61000-4-2
• Burst Measurements according to IEC/EN 61000-4-4
• Surge Measurements according to IEC/EN 61000-4-5
• Power Fail (Voltage Dips) according to IEC/EN 61000-4-11 and IEC/EN 61000-4-29
• Conducted interference according to EN55022, 150khZ - 30MHz

The final measurements for the CE marking are outsourced to an accredited EMC laboratory.